| Designed by Chris Rose, ATC (Athletic Trainer Certified)
DIRECTIONS FOR USE:
I. Remove insert from body
II. Heat Insert using one of the following methods, repeating as necessary:
1. Heat gun the moldable insert until it becomes pliable.
2. Microwave insert on top of wet paper towel for 1'/: to 2 minutes.
3. Boil water and heat moldable insert for 1.5 to 2 minutes at full boil (insert should float).
PLEASE NOTE: INSERT WILL BE HOT. USE TONGS OR GLOVES TO HANDLE. NEVER PUT NEXT TO SKIN WHILE HOT.
III. Remove insert from heat source. Immediately place pliable insert (soft enough to mold to patient's big toe) narrow end first, inside pocket of Rose Toe Brace™ and apply to patient for custom molding
Please Note: Patient must keep foot motionless while insert hardens. Please allow up to three minutes before removal.
|
